Dummy spawn time must be longer

Stahlor

The spawn time of the dummy skeletons is too short. When you have long lasting dots down you agro the new spawning skeleton and it badly effects your dps result.

Callous2208

So just wait a few seconds without attacking him and start fresh.

Izaki

It doesn't affect your DPS result as far as I'm aware. But basically, you need to move your DoTs away as soon as the fight ends.

disintegr8

It resets if you stop the attacks for a short time.

LordGavus

It can be a pain and it would be nice if it took longer to respawn.
For now best thing to do is recast your AOE away from the dummy after it dies.

SirAndy

For long running dots, like caltrops, you can simply recast them away from the dummy once the fight finishes to move them away from the spawn point.

Stahlor

No it respawns, and gets the dots. I'm under atack for the whole time until my dots run out. After that I get my result. Only one result, otherwise i would get a very low second result. I'm one xbox though.

SquareSausage

You should get a result exactly when it dies.

Callous2208

SquareSausage wrote: »

You should get a result exactly when it dies.

Yea I always get the result as soon as he dies.

Splattercat_83

Mine doesn't, in my guild if we are grouped togetherand practicing it won't give me my time until everyone gets finished

Stahlor

Callous2208 wrote: »

SquareSausage wrote: »

You should get a result exactly when it dies.

Yea I always get the result as soon as he dies.

Put caltrops or ash cloud down and you will agro it again when it respawned. Then you have to wait till the agro is gone before you get your result. If you would get your result immediately when it dies, you would get a second one, because you did damage again for a few seconds. But its not like that...
So the only method right now is putting your dots anywhere quickly, after it has died - a little bit stupid.