Maintenance for the week of December 2:
• PC/Mac: NA and EU megaservers for patch maintenance – December 2, 4:00AM EST (9:00 UTC) - 9:00AM EST (14:00 UTC)
• Xbox: NA and EU megaservers for patch maintenance – December 4, 6:00AM EST (11:00 UTC) - 12:00PM EST (17:00 UTC)
• PlayStation®: NA and EU megaservers for patch maintenance – December 4, 6:00AM EST (11:00 UTC) - 12:00PM EST (17:00 UTC)
[QoL REQUEST HOUSING] Introduce checkpoints
I request to introduce the possibility to set "last checkpoint" of a house configuration to which I can revert to in case I need to within ONE active house building session.
This should work as follows:
I have a house that I am quite satisfied with but not sure if this is the final one. I have a few ideas how to modify but I don't know if it is an actual improvement over what I have right now.
Now I should be able to sett ONE single checkpoint that saves the house as is. Now I will start modifying it. In case I see that my ideas for modification are not really working out well, I can revert to the state my house had been when I set the checkpoint.
Of course I know that I can do this by pressing multiple times Y for removing previous steps. I would have to remember myself how many and which modifications I have to revert to come to my desired house setup. It also does not work when I use this function several times. For instance I have a setup that I want to modify. I proceed to implement let's say 10 modification but during this process I remove 3 steps and start from there to continue with 10 other modifications. But then I see the entire thing is going into the wrong direction and it would be better to start again from the last point where I was happy with. It would end up in a complete mess and here a checkpoint would help tremendously.
Of course when I travel outside my house this checkpoint would be removed and set to the state of the house the moment I left it.